BRP Evinrude E-TEC Specifikace stáhnout pdf (Strana 42)

TROUBLESHOOTING

SYMPTOM POSSIBLE CAUSE

Starter motor will not operate • Shift handle not in NEUTRAL.

• Fuse blown. Refer to

Fuse on page 30.

• Battery is dead.

Engine will not start • Not following starting instructions. Refer to Start-

ing, Stopping, Shifting

on page 14.

• Fuel tank empty.

• Fuel hose kinked.

• Fuel system contaminated with water or dirt.

• Fuel filter obstructed.

• Throttle not at IDLE. Return throttle to IDLE.

• Spark plugs incorrect. Refer to

Specifications on

page 46.

• Spark plugs improperly gapped, carboned,

burned, or wet.

• Fuse blown. Refer to

Fuse on page 30.

• Flashing “Water Temp” or hot light, refer to En-

gine Monitoring

on page 20 and Engine Over-

heating on page 22.

• Flashing “Check Engine” or “Chk Eng” light, refer

to Engine Monitoring on page 20.

Engine will not idle properly • Debris on propeller.

• Spark plugs damaged or incorrect. Refer to

Specifications on page 46.

• Fuel system contaminated with water or dirt.

Engine loses power • Spark plugs damaged or incorrect. Refer to

Specifications on page 46.

• Fuel filter obstructed.

• Fuel system contaminated with water or dirt.

• Water intakes obstructed and cooling system not

operating correctly. Refer to

Engine Overheating

on page 22.

• Oiling system malfunction.

• S.A.F.E. protection mode activated. Refer to En-

gine Monitoring on page 20.

Engine runs, but makes little or

no progress

• Propeller hub loose, slipping.

• Propeller blades bent or missing.

• Propeller shaft bent.

• Propeller debris.

Warning system activates • Refer to Engine Monitoring on page 20.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 61 62

Komentáře k této Příručce

Andrzej Olszak 03 Jun 2025 | 12:36:35

Dobry silnik

BRP Evinrude E-TEC Specifikace Strana 42

Komentáře k této Příručce

Související produkty a manuály pro Motor BRP Evinrude E-TEC